When the ‘Wire Configure’ form is displayed. Check the ‘Equipment’ box to open the equipment configuration section of the form.
In the example below, the structure is an Portal and the equipment will be attached via the gantry.
The available attachment points are displayed. In this example, there is 'Mast A', 'Mast B' and 'Gantry'. Select 'Gantry' and the form will update to display 'SPS' options.
Click ‘Add SPS’ to display the 'Add SPS' form.
Select the required piece of SPS from the drop-down menu and choose the positioning of the SPS be entering 'Offset From Support'. The value shown here will place the wire point at the entered distance from Mast A.
Some SPS will allow rotation on the gantry, if the selected SPS is required to be rotated, then input the rotation value in the 'Rotation' field.
Click 'Confirm' to accept.
Once confirmed, Linear Draft will automatically add a Droptube. To edit the Droptube, click 'Edit Droptube' at this point.
The SPS and Droptube will now be visible on the 'Wire Configure' form.
To add a bracket, click ‘Add Bracket’ to display the 'Add Bracket' form.
Select the bracket that is required and click 'Confirm' to accept.
The 'Wire Configure' form will once again be displayed, now with the addition of the bracket.
The ‘Support’ will populate automatically and will display the first available configuration that can be used with the specifications that you have chosen. The 'Support' can changed by selecting from the options in the 'Support' drop-down menu.
N.B. Adjustments can be made to the support/mast directly from the 'Wire Configure' form. To do so, select the mast line on the form and the 'Edit Support' button will be enabled.
Also, adjustments can be made to the gantry directly from the 'Wire Configure' form. To do so, select the gantry line on the form ('Gantry - 300 x 90 x 41kg DC' in the example below) and the 'Edit Support' button will be enabled.
Select the 'Edit Gantry' button and the 'Edit Gantry' form will be displayed.
From here, the 'Height' and 'Length' of the gantry can be adjusted. To accept the selection, click 'Confirm'.