Select the ‘Structure Place’ button from the Linear Draft toolbar and follow the prompts.
At this point you should select one marker.
After selecting the marker point, accept the choice by right clicking the mouse button. A new prompt will appear asking you to select the rails.
Left and right rail selection will define the orientation of the structure and its annotation box, therefore, the left and right rails must be chosen as if you were looking at the rails in direction of increasing chainage.
In the example below, the chainage is increasing from right to left.
Accept the rail selection by left clicking the mouse button. Once accepted, another prompt will appear asking you to select the right rail. The right rail for a wall attachment will be the corresponding rail from the one previously selected.
Accept the selection by left clicking the mouse button and the ‘Create Structure’ form will appear.
Choose type 'Wall'.
The ‘Create Structure’ form shows a view of the structure and displays boxes that require text to be added as well as displaying engineering values that can be edited.
There will no Label, Mast Length, Gap, ToF or Foundation information displayed. This is because the wall attachment does not require this information.
Brackets, equipment and wires will be added directly to a wall.
The bearing and distance from the running edge of the closest rail can be edited. Once you have configured the wall attachment, click 'Confirm' to continue.
There will be no visual representation of a wall attachment in the 3D view. However, the brackets, equipment and wires (when added) will be shown.