When the ‘Wire Configure’ form is displayed. Check the ‘Equipment’ box to open the equipment configuration section of the form.
In the example below, the equipment will be attached directly to a soffit attachment.
The available attachment points are displayed. In this example, there is only 'Mast A - Tunnel Feeder Droptube', click ‘Add Bracket’ to display the 'Add Bracket' form.
Select the bracket that is required and click 'Confirm' to accept.
The 'Wire Configure' form will once again be displayed, however the equipment will be displayed on the form.
The ‘Support’ will populate automatically and will display the first available configuration that can be used with the specifications that you have chosen. The 'Support' can changed by selecting from the options in the 'Support' drop-down menu.
N.B. Adjustments can be made to the support/mast directly from the 'Wire Configure' form. To do so, select the mast line on the form ('Mast A - 203 x 203 x 46kg/m UC' in the example above) and the 'Edit Support' button will be enabled.
Select the 'Edit Support' button and the 'Adjust Support' form will be displayed.
From here, the 'RECOS' and mast 'Length' can be adjusted. To accept the selection, click 'Confirm'.