To remove an individual wire point at a structure, open the 'Wire Manager' from the Linear Draft toolbar.
The 'Wire Manager' form will be displayed.
Select the wire, from the 'Selected Wire' drop-down menu, that contains the wire point that you want to remove.
The wire point will be associated with a structure. Locate the structure from the 'Structures/Track' column of the form and click 'Delete' on the right-hand side.
This will remove the structure from the list. The graphical elements and the wire point data will be removed from your model. The structure will remain, only now without the equipment.
The image below shows an example of a structure with its wire point removed.
N.b. The structures immediately before and after will not be affected. The wire will still be visible but will bypass the structure. If the new span length exceeds its permitted maximum, then droppers will be removed from the span. Structures would be required to move, or additional structures added so that the span becomes of an applicable length. Once the span is of a correct length, droppers will be displayed.